Join Date: Mar 2019
Location: North Metro Atlanta
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 2 Post(s)
Thanked 1 Time in 1 Post
Groaned at 0 Times in 0 Posts
iTrader: 0 reviews
Just completed this today per OP instructions and pics. I wanted to use the fogs as DRLs w/out the headlights as I lost my DRL functionality when I swapped in LEDs for the high beam bulbs. Found another post it fix it but that's for another day - requires a special wire harness w/ resistors.
-my new cabin relay didn't have any pin numbers. 85/86 are the low power switch pins which will pass a continuity test while 87/30 are the high power pins that are normally open circuit.
- my add-a-fuse had two fuse slots and both needed fuses installed to work.
- for the firewall wire, I pulled the rubber stopper edge away from the engine bay and was able to push a stiff wire w/ good insulation around it rather than poking a hole through it. There is a metal edge but it shouldn't rub once it's through.
2014 Touring 64K mi
Last edited by stephenmiata; 05-22-2019 at 03:20 PM.
Reason: update on completing the project