Mazda6 (Atenza)
Technical / Performance / Model
Visual / Audio
How-To / DIY Section
Product Reviews
Post reviews about products for the Mazda 6 here.
Media
Other Mazda Discussions
Classifieds
Our buy and sell area. Please note that you need to have a minimum of 50 posts in order to post anywhere in this section.
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
Latest Posts
-
Hi everyone. I'm experiencing a bit of frustration with my 2006 Mazda 6 3.0L V6 Hatchback. I plugged my XTOOL diagnostic computer to this damn thing and the CEL is on in the vehicle. I tried erasing it, and it comes back right away, so there's obviously a problem. It has 148, 400 miles on it...3 replies 77 views
-
Good evening -- I attempted to replace the ECT sensor on my '09 2.5. The part purchased is threaded, and fits into a 19mm socket. I'm very confused, as the one in the car, after getting the connector off, just spins.. and spins.. and spins.. doesn't loosen, doesn't tighten. I put the...3 replies 2K views
-
Well, a few weeks after replacing my head gasket and rebuilding a good portion of the engine, my cylinder head is cracked. I had a bad thermostat that didn't open at all, and within a 5 mile drive my coolant got to 240°F, and the rest is history. SO. I'm ordering a new head from Mazda, just...6 replies 110 views
-
Mazda 6 2011 2.5L Suppose that outside temperature is at 25 celcius degrees. If i set the desired temperature at 21, i only receive hot air, but IT is suppose to cool down. Hot air Will come out the ventilation system for any temperature over 17 degrees. If i want to receice cold air, i need...0 replies 22 views
-
Hi everyone , new member here on behalf of my wife's 2016 mazda 60 replies 17 views