Some of you may have seen my facebook page about this.
I custom build front splitter lip kits for the Mazdas and have been asked by a few people to do more Mazda 6 models.
In order to start I would require a decent amount of registered interest and what models people would be asking for, so please respond if your interested and what model you have.
And if you want one I can add you to a pre-order list (no money required at first) in order for you to reserve yours if I do start making them.
For more information and pictures, check out this page here:
A few FAQs:
What are they made of:
-They are made of a high quality marine ply that and coated multiple times in an enamel hardening paint basically making weather proof and impact and scratch resistant. They are then edged with a metal reinforced hardened rubber. In the end, this is basically impossible to break.
What colours do they come in and how much:
-They come in matte black or standard black (shiny but not mirror finish) for $260 including all extra mounting hardware, or can be vinyl wrapped in gloss black or carbon fibre print for an extra $35.
How does it mount up:
-It mounts on to all original mounting points under the car without needing to remove the splash guard keeping the install clean and easy.
Why should I buy one:
-Not only does it look awesome on your car giving it a much more aggressive look, but it protects your front bumper from any hits and scrapes on driveways and nasty speedbumps.
On most cars we have found that it actually increases ground clearance as part of the install it removes the original scrape guard (usually 3-4cm) which is much thicker than the splitter (1cm)
Have a chat to some of the guys who have already purchased them and you'll see that you can put these through hell without a worry, a must have if you lower your car!